Part Number: TS3A5018 Hi TI team,
We found that there is something internal pull low when we select the channel.
Please refer the diagram as below, there are 2 cascaded mux switches in the path of our each device.
We set the latter in NO channel…
Part Number: TS3A5018 Other Parts Discussed in Thread: TS3L110 Hi Team,
Can TS3A5018 be used as 100M ethernet switch?
it seems it can support 300MHz signal, so it should be able to support 100M ethernet switch.
Is there any other risk?
Thanks…
Part Number: TS3A5018 Hi team,
My customer want to know the time delay parameter between VCOM and NC, NO under below condition:
EN pin connect to ground, IN pin is controlled by default fixed level, and VCOM pin is connected to NC or NO.
Thanks…
Part Number: TS3A5018 Hi TI teams.
There is a phenomenon in my case as below. I tried to use the 2 TS3A5018 cascaded in my SPI application.
I'm very confuse about COM3& COM4 delay 452us... and the voltage is rising from 0.8V not 1.8V.
Please refer…
Part Number: TS3A5018 Other Parts Discussed in Thread: TS5A2053 , HD3SS3411 , TS3A5223 Hello,
On my PCIE GEN5 Host design I need to support PCIE_REF_CLK (Connector pins A13/A14) to be an input or output from a SoC. The SoC pin is bidirectional.
The…
Part Number: TS3A5018 Other Parts Discussed in Thread: TMUX1574
Hi
As diagram shows, I use two TS3A5018RSVR series stages for 4 scenario input/output for SPI flash, but I can't get any response, MISO, from my device (SPI flash).
So I want to check…
Part Number: TS3A5018 Hi Team,
Customer is designing TS3A5018.
Would you please provide comment for the following questions?
Provide TS3A5018 RSVR, 8 to 4 port switch SNP model for customer simulation requirement.
Customer would like to do simulation…
Hello,
The following specification can be found in the TS3A5018 datasheet:
Indicating that while V+ = 0V (power off), you may expect +/10 uA leakage current on the input/output signal pins at the specified I/O voltage range.
If you are looking…
