Hi,
For TXB0106 ESD testing, we use other ESD standard. If you want to use translation in aotumotive, could you check TXS0104E-Q1 and TXB0104-Q1
Thanks
Wei
Is the output on the A & B signals 0 to 12V? If so than you will need to use a voltage divider to make the singals from 0 to 5V. This is due to the level shift chip use on the inputs of TMDSHVMTRPFCKIT. The part number is TXB0106.
Is this encoder attached…
Hi Biser,
Thanks for the prompt response again!
In page 2 of the DM Rev H, the bullet points describing the 3 MMC, SD and SDIO ports has this comment: MMCSD0 has Dedicated Power Rail for 1.8.V or 3.3-V Operation
Can you please recheck OR search…
Hi Abhi,
In terms of the operation, this device is application specific to MMC. But, we understand that there are various requirements as the standards evolve.
I have attached a ppt which could be useful for us and hopefully for you to evaluate the…
Hello Alex,
unfortunately I'm still struggling with the JTAG connection.
The figure shows the schema of my pcb. I seems to me that I've put all the cap needed, VDDSW and VDDB are connected and RST is pulled up with 22k.
I first tried to connect…
Other Parts Discussed in Thread: ADS8326 , TXB0106 , SN74LVC1G125 , SN74LVC2T45 Hello-
For the ADS8326 running off 5V, what is the maximum low outpout voltage for Dout at 2mA load?
For the ADS8326 running off 5V, what is the minimum high outpout voltage…
Other Parts Discussed in Thread: SN65LVDS048A , TXB0106 The idea is to interface 5V differential signals from an encoder and hall sensors on a motor to the QEP and CAP peripherals of a F28035/28335 microcontroller. Is the only way to use TXB0106 to convert…
Other Parts Discussed in Thread: TXB0106 Hi All,
My requirement is as follows: I am trying to interface a 5V micro to a 3.3.V Touch screen controller that communicates over SPI bus. I need to translate the signals from 5v to 3.3 and vice versa.There…
Hi Ramesh,
You are right. The signals are fine on the B side of TXB0106 , but are erratic on the A side. I think that is causing all the trouble. I have ordered a new chip for replacement and hopefully that will fix the issue.
Thanks, Tamil
