Part Number: UCC14241-Q1 Other Parts Discussed in Thread: UCC21710 , Tool/software: Hi,
This thread is A follow to this post on the forums: UCC14241-Q1: RLIM Selection for UCC14241 for UCC21710 based SiC Gate Driver
Based on the conversation from…
Part Number: UCC21710-Q1 Other Parts Discussed in Thread: UCC21750 , TINA-TI Tool/software: UCC21710 PSpice Transient Model - If we use this spice model for simulation in LTspice XVII, facing the below issue.
UCC21710 Unencrypted PSpice Transient…
Part Number: UCC21710 Tool/software: Hi,
In my project the IN+ and IN- pins are fed with complementary pulses but there is no Output coming at OutH/L
the Vgs is clampled to -5V
in my design Vdd is 20v and Vee is -5 V
Part Number: UCC21710 Tool/software: Hi,
I am using ucc21710 for driving the half bridge module MOSFET half bridge module in an inverter application.
the first waveform is when we simulated a desat trigger ,the setup is made with a load (90A @400V…
Part Number: UCC21710-Q1 Other Parts Discussed in Thread: UCC21710 , TPS564255 , UCC21750
Hello,
I am observing some erratic behaviour in my gate drive signals from the UCC21710 with an external gate drive BJT buffer. The first few switching cycles…
Part Number: UCC21710-Q1 Tool/software: For this part UCC21710QDWRQ1, when the Pin 1 Ain input voltage is 1.3V, what's the duty cycle output at Pin 16 APWM under room temperature 25 degree C, and what's the duty cycle tolerance range?
How about 2.15V…
Part Number: UCC14141-Q1 Other Parts Discussed in Thread: UCC21710-Q1 Tool/software: Dear Team, We are using the UCC21710-Q1 gate driver in a DC-DC converter with a full-bridge topology. The gate driver is powered by a UCC14141QDWNRQ1 DC-DC module, which…
Part Number: UCC21710 Tool/software:
.
Hello,
I am observing strange behavior of output of ucc21710. Attached are the images and schematics.
Yellow- Gate pulse from microcontroller(25khz).
Blue - Voltage between gate and source keeping Vds=0…
Part Number: UCC14241-Q1 Other Parts Discussed in Thread: UCC21710 , , UCC15241-Q1 Tool/software: Hi,
I am using the UCC14241 IC to provide dual output power rails for a SiC MOSFET gate Driver (VDD: +15V; VEE:-5V). The gate driver IC I'm using is UCC21710…
Part Number: UCC21710 I am driving 2 SiC MOSFETs in parallel using a single UCC21710 IC. Could you suggest a recommended circuit connection for the CLAMP pin? Can we short directly both GATES of the MOSFET and connect to the clamp pin as shown below?
