Part Number: UCC5871-Q1 Other Parts Discussed in Thread: UCC5881-Q1 Tool/software: Hi Team,
Can I connect the UCC5871-Q1 driver IC to drive three parallel IGBT power modules (CM1200DW-40T)?
Each IGBT has an internal gate resistance of 0.63 Ω. Considering…
Part Number: UCC5871-Q1 Other Parts Discussed in Thread: TINA-TI Tool/software: Hi Team,
I wanted to simulate Gate driver IC [UCC5871-Q1] in TINA-TI software, but I am not able to find TINA-TI SPICE model (.TSM file), can you please provide these files…
Part Number: UCC5871-Q1 Tool/software: Hello,
I was going through the datasheet of the UCC5871-Q1 and read in section 8.2.2.7 (OUTH/ OUTL Outputs) that the minimum gate resistance must be no less than 1.5 ohms. I want to understand why there is a constraint…
Part Number: UCC5871-Q1 Tool/software: Hello ,
Is the gate driver UCC5871-Q1 suitable for 1500V applications? In the data sheet, the maximum isolation working voltage is specified as 1500V (AC). However, this value refers to a sine wave voltage and…
Part Number: UCC5871-Q1 Other Parts Discussed in Thread: UCC5870-Q1 Tool/software: Looking at https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1277141/ucc5871-q1-spice-model it points to use a pin to pin equivalent…
Part Number: UCC5871-Q1 Other Parts Discussed in Thread: UCC5880-Q1 Tool/software: Hi Ti,
I am currently using the AI6 channel to read temperature information from a sensor. However, I consistently receive a reading of 0x0000 whenever I attempt to…
Part Number: UCC5871-Q1 Other Parts Discussed in Thread: UCC5870-Q1 Tool/software: Hi Experts,
the device is marketed to have a peak drive strength of 30A but in the recommended operating conditions we ask the customer to limit to 15A - "External gate…
Part Number: UCC5871-Q1 Hi Expert,
My customer is using UCC5871-Q1 in their project. When they change the RGON and RGOFF to 200Ohm, the OUTH voltage goes into 13V rather than normal 18V.
From my perspective the 2 resistors are used to minimize ringing…
Part Number: UCC5871-Q1 Hi Expert,
My customer is using the latest silicon in their project, only to find that the VCC1 UVLO is triggered. However, the voltage of VCC1 is 5.12V which is higher than level2. What's more, when customer disable VCC1 UVLO…
Part Number: UCC5871-Q1 Tool/software: Hi!
I am developing inverter based on SiC.
Working voltage up to 1200 abs max.
Isolation 5000 as I see would be enough.
But my standard requires clearance 12.5mm.
I think I cannot any driver with integrated…
