Part Number: WL1807MOD Tool/software: Linux Hi Champs,
We would like to know following question.
If you know 1) question, please prior to answer 1) first.
1)Could you please tell us how to adjust ACK time out parameter ?
2)Do you have measure…
Hi,
I checked with our experts on this. The issue is that with calibrator you cannot use an AP to send the packets. Calibrator is expecting the packed from a "test box" So I believe the best option for this is to use another setup with calibrator…
Part Number: WL1807MOD Hi,
We want to incorporate WL1807MOD in our design due to two requirements which are mandatory to be supported in the product: 1)that it supports upto 10 nodes connection as an AP and 2)It supports -40 to 85 Degree C temperature…
Part Number: WL1807MOD
Hi Champs,
When we send modulated signal on the GPIO12 (Tx Active), it is usually toggle High/Low according to transmit signal ON/OFF at AP mode as left side waveform.
On the right side picture, it failed and signal always…
Part Number: WL1807MOD
Hello Expert,
We are using WL1807MOD in both access point and station side.
In station side(use wpa_supplicant), we do not know how to limit the connection to 11g(2.4GHz) or 11j(4.9GHz) only.
Do you know how to limit the…
Part Number: WL1807MOD 1. Is the WL1807 is recommended for new ZIGBEE application, 802.11S?
2.Can it be used for WIFI direct too?
3.Is the only difference between WL1807 and WL1805 is the operating temp range?
Part Number: WL1807MOD Hello team,
My customer wants to start a new design with WL1807MOD, could you please advise what is the longevity and if this device is still supported by TI.
Thanks in advance
B.regards,
Shai
Part Number: WL1807MOD Hi, pin #64 is listed as GND in the pinlist, but shows a pull-down resistor on the reference schematic. Is this truly a GND pin or does it set a logic level? In our design we left this pin floating, and I wonder if this could cause…
Part Number: WL1807MOD Other Parts Discussed in Thread: WL1837MOD hi
can anyone help me of getting the BIN file generated from WL1837MOD_INI_FCC_CE.ini file ?
regards.
Zakaria.
Part Number: WL1807MOD Tool/software: Linux Hi,
There is a situation where VoIP broadcast packets at 20ms intervals are buffered for about 200ms in the downstream from the AP to the ST and are transmitted together. Is there a setting to transmit with…
