Other Parts Discussed in Thread: TINA-TI
I have struggled a lot getting the simulation for the LMH32401 to work.
I think that the symbol on the schematic package extracts the pin names in a different order as to the simulation model.
From the library part I can see this sequence (* LMH32401 - Rev. A)
.subckt LMH32401A I_IN+ VCC VEE VOS_CNT VOCM AMB_CNT GAIN_CNT OUT- OUT+
however the netlist generated from the schematic is:
X_U1 I_IN P3_3 0 VOD VOCM AMB_CNCL GAIN N00322 N00318 LMH32401
The figure shows how I think the sequence is. (unfortunately I cannot load the figure)
This way I can get results thats almost believable, although output does not track V0cm.
Can you please confirm if this is the correct way to use the simulation model?