OPA4188: OPA4188AIPWR

Ajay Sahu

Part Number: OPA4188

Hi,

I am using OPA4188AIPWR for low side current sensing circuit. In the normal condition output I am getting is OK but if I introduce noise at the input I am not getting the exact waveform it's a noisy one. I am using first order low pass filter at the output of the OPAMP. Is there any other filter design I can use so that I get the desired waveform. If you suggest it would be helpful. FYI The output of the circuit goes to ADC.

Regards,

Ajay Sahu

over 2 years ago

0 Thomas Kuehl over 2 years ago

TI__Guru* 93105 points

Hello Ajay,

Are you able to share your OPA4188 schematic, power supply arrangement and observed waveforms? That would provide us much more information to consider. Since this is a low-side sensing circuit just how low does the output voltage have to go?

If filtering is applicable we likely could configure the low-side voltage sense circuit to include an active low-pass response to help reduce the noise.

Thanks, Thomas

Precision Amplifiers Applications Engineering

0 Ajay Sahu over 2 years ago in reply to Thomas Kuehl

Prodigy 225 points

Hi Thomas,

My issue has been resolved.

Regards,

Ajay

Amplifiers

Amplifiers forum

OPA4188: OPA4188AIPWR