OPA810: Layout question for OPA810

Xiaoqiang Shen

Part Number: OPA810

Hello,

Question:

1) Should I remove all the ground under OPA810 from top to bottom layers, including inner GND plane?

2) How to connect front end resistor/capacitor ground? Should it connect through top layer ground ? Or should I remove top layer ground & go to inner layer GND plan with VIA?

over 2 years ago

0 kai klaas69 over 2 years ago

Guru 140200 points

Hi Xiaoqiang,

section 11.2 of datasheet shows a recommended layout.

Kai

+1 SimaJalaleddine over 2 years ago

TI__Mastermind 22270 points

Hello Xiaoqiang,

For high speed layouts, it is suggested to remove inner planes around the output and inputs of the device. The opening can just be underneath IN+, IN-, and Out and the component attached to this pin as shown in Figure 11.1 under the section Kai pointed out.

Preferably, via to ground plane. If this isn't possible, then you may connect it to top layer ground. Top layer ground should have scattered vias throughout board to inner ground.

Thank you,

Sima

Amplifiers

Amplifiers forum

OPA810: Layout question for OPA810