• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 49 subscribers
  • Views 117 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

OPA548: Increase current source

Mustafa Acun
Prodigy 20 points
Part Number: OPA548
Other Parts Discussed in Thread: OPA547

Hello,

I am a novice in these matters, so I apologize for any incomplete or incorrect explanations.
I have a 10 V-20 mA signal generator. I can adjust the frequency and amplitude.
I want to drive the BLDC motor the way I want. Of course the current is insufficient. 
Operating voltage range: 12-24V
Idle current: 55mA
Power 7.5W

I have examined many amplifier circuits but I could not find a circuit I wanted. 
Will the OPA548 integration help me? 
If you have a different suggestion, could you share it with me?

Thank you in advance.

  • 0
    TI__Guru* 93105 points

    Hello Mustafa,

    We need a bit more information about your BLDC motor drive requirements before we can make the best power op amp recommendation.

    • You mention an idle current of 55 mA, but what is the peak current requirement of the BLDC motor?
    • What power supply do you have available to power the op amp? Do you plan to use a single supply, or a dual supply?

    If the peak output current required doesn't exceed about 0.75 Amperes the OPA547 may be a good candidate for the BLDC motor driver. See FIGURE 11, Motor Drive Circuit, in the datasheet for an example circuit.

    Regards, Thomas

    Precision Amplifiers Applications Engineering