INA300-Q1: how to consider hysteresis setting in worst case

Noriyuki Takahashi

Part Number: INA300-Q1

Hi team

The device has the hysteresis setting, but there are no max & min value.

In general, when they consider to design the hysteresis setting in worst case as the comparator, how should they design the system without the max & min value?

Regards,

Noriyuki Takahashi

over 1 year ago

+1 Guang Zhou over 1 year ago

TI__Mastermind 30720 points

Hi Noriyuki Takahashi,

Can you elaborate what you mean by “design the hysteresis setting in worst case”? I assume you’re referring to the input hysteresis of 2, 4 and 8mV.

Since only typical values are available, the best I can recommend is to choose a value that is closest to desired.

Regards, Guang

0 Noriyuki Takahashi over 1 year ago in reply to Guang Zhou

TI__Genius 10150 points

Thanks. I am confirming their use case now. Please let me ask to your team again.

0 Noriyuki Takahashi over 1 year ago in reply to Noriyuki Takahashi

TI__Genius 10150 points

I will post again in internal forum.

Regards,

Noriyuki Takahashi

Amplifiers

Amplifiers forum

INA300-Q1: how to consider hysteresis setting in worst case