Other Parts Discussed in Thread: TPS62130A,
As mentioned in the other thread, I was aiming to use the INA223 to adjust the TPS62130A output voltage so that a constant power is delivered to a load resistance. I believe I have achieved that, and would appreciate a review of my design to make sure that I can believe the results.
Across Monte Carlo and Worst Case simulations I was seeing about 0.08% variation in output power, which seems too good. Is there anything else I should be adding/testing to make sure that my results are believable? Attached is the PSpice schematic that I have created for this circuit.
Thanks,
Drew
