• Locked Locked
  • Replies 2 replies
  • Subscribers 50 subscribers
  • Views 1495 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Need Help with OPA2314

ramin anushiravani
Intellectual 350 points
Other Parts Discussed in Thread: LF347, OPA2314, TINA-TI

Hi, all--

I'm not sure if I'm posting in the right section, so let me know if I have to move this to somewhere else! I need help with OPA 2314. I'm trying to design a preamp for Knowles mics ( NR23158). I've been using LF347 the results is acceptable. I'm trying to use OPA 2314 now, but I'm getting a very high oscillation from the circuit with the gain of 50. Basically, even if I don't connect my mic to the circuit there's this constant noise in the circuit. The bypass capacitor helped but it's still not acceptable. I'm pretty sure there's something I'm missing. There should be a difference between LF347 and OPA 2314. I checked the datasheet and they seems to have an almost same characteristics for my preamp. Also, does it matter if I used like 50k and 1k to get the gain of 50 and maybe 500 and 10 ohms to get the same gain? Should I use different values for my capacitor and resistor? I don't think 50 gain is too high, where is this Oscillation coming from. I'm very new to this, I'd really appreciate it if someone can help me out here.

Thanks!

Ramin

  • TI__Prodigy 515 points

    Ramin,

    Thanks for posting your question.  I have moved your post to our Precision Amplifiers forum to get help on your question.

     

  • TI__Guru 60570 points

    Ramin,

    OPA2314 should be very stable especially in high gain configurations - the higher gain the greater stability at the expense of the lower effective bandwidth (see below).

    Therefore, if your circuit is truly unstable, there must be more to your configuration than you told us - do you drive a large capacitive load at the output?  If you need additional assistance please provide us with your full schematic including bias and input voltages.  Attached please fine the Tina-TI circuit you may use for simulations.  

    Running a small-signal transient analysis result in a very stable response that goes hand-in-hand with the ~90 deg phase margin (see below).

    OPA314 Gain=-50.TSC