Not sure if the forum is the right place to call this to TI's attention, but the datasheet for the OPA1641 audio op amp (and it's siblings) contains obvious errors in the electrical characteristics table.
For example, the input noise density at f=10 Hz is given as "f=100 Hz," where it should obviously be a numerical value. The input bias current is given as a range in volts, while the input offset current is specified in decibels. I haven't gone through the table with care, so there are probably others.
Obviously somebody cut-and-pasted a bunch of cells where they don't belong, and nobody bothered proofreading the table before the datasheet was released to the public. A bit sloppy, TI, no?
--Dan Menes