This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

OPA180: OPA180 Chopping Frequency

Part Number: OPA180
Other Parts Discussed in Thread: OPA188

Dear Sir,

Our custoemer would like to know about chopping frequency of OPA180. According to the OPA188 datasheet, there is a figure about off-set correction frequency, 3us, on page 16. I think it is the same as chopping frequency of OPA188. Are there any documents describing about chopping frequency of OPA180? Please advise.

Thanks,

Koide