• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 49 subscribers
  • Views 856 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

INA114: INA114 bottom marking

Dimitrius
Intellectual 1315 points
Part Number: INA114

Hello, All,

My customer noted that inside of single lot bottom marking is vary. Am I right that bottom marking is the unique incremental chip number inside of lot? 

The second questions in surface condition. Top surface is smooth and bottom surface is rough one. Is this OK

Best regards,

Dmitry

  • 0
    TI__Guru* 93105 points

    Hello Dmitry,

    I checked the assembly documentation for the INA114, it only specifies the the topside marking marking requirements. The topside image corresponds to the correct format. There aren't instructions for bottom side marking of the device in that documentation.

    I checked with our Quality department and they indicated that the underside is sometimes marked by the product assembler. The codes they use are for internal purposes and lot tracking.

    The finish on the topside may be different than on the bottom side. It comes down to the injection mold finish. The topside may be made smother to accommodate the product laser marking.

    Regards, Thomas

    Precision Amplifiers Applications Engineering