• State TI Thinks Resolved
  • Locked Locked
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 49 subscribers
  • Views 578 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LMH6518: Will LMH6518 accept differential input?

diverger
Expert 1195 points
Part Number: LMH6518

In the datasheet, it says:

The input is differential but is driven single-ended as long as the conditions of Table 6 are met, and there is good
matching between the driven and undriven inputs from DC to the highest frequency of interest.

I'm a little confused, is it mean "although the input is differential, but it can ONLY be driven signle-ended" or "although the input is differential, but it can ALSO be driven singled-ended"? I must make sure this, because I'm considering put another full differential amp before it.

Thanks.

  • 0
    Guru 140200 points

    Hi,

    your phrase can be found in section 8.2.1.2.2 and is referring to the application shown in section 8.2. But in section 7.3.1 the following is mentioned:

    "7.3.1 Input Preamplifier

    The LMH6518 has a fully differential preamplifier which has a consistent 150-kΩ impedance across all gain
    settings. The LMH6518 is also driven with a single-ended signal source. The preamplifier has two gain settings.
    See Input and Output Considerations for details."

    Kai

  • 0 in reply to kai klaas69
    TI__Genius 17186 points
    A single ended signal is technically differential with respect to ground. So ALSO.
  • 0 in reply to Sean Cashin
    Guru 140200 points

    Hi Sean,

    hmm, the original poster is right somehow. The datasheet is indeed confusing in this point because it only discusses the connection of a single ended signal. Even the eval board is only supporting this configuration.

    Kai

  • 0 in reply to kai klaas69
    TI__Genius 17186 points
    Hi Kai,

    You are right as always Kai. There are no examples in the datasheet showing differential input either, and all the specifications are for "single ended input drive". I don't see anything preventing a fully differential input however, other than a lack of examples. Do you have concerns?

    Best regards,

    Sean