LMC7101: Pin-to-pin compatible part with lower offset?

Heinrich Venter

Part Number: LMC7101
Other Parts Discussed in Thread: TLV9001, OPA170, , LMC7111, TLV2711, TLV2721, TLV2731

Hi, does anybody know of an op-amp with lower input offset voltage, that is pin-to-pin compatible with the LMC7101A? This part has positive supply on pin 2, instead of pin 5 which seems to be the industry standard. Is there a way to search op-amps according to pin-out? Thank you.

over 5 years ago

0 Paul Goedeke over 5 years ago

TI__Mastermind 30600 points

Hi Heinrich,

Right now there is no way to search for this unique pin-out that I am aware of. We are looking into this to see if there is some way to make this easier.

I would look at the TLV9001 in the DBV package, that should be pin to pin and have lower maximum offset. It doesn't have the same supply voltage range (only supports 5.5V, not 15V) so if that's an issue, you can look at the OPA170 in the DBV package.

If you can share with me your circuit configuration and what your desired offset voltage level is (typical and max), we can refine our recommendation.

Best,
Paul

0 Heinrich Venter over 5 years ago in reply to Paul Goedeke

Prodigy 70 points

Hi Paul,

I'm using 3.6 V, so no problems there.

The TLV9001 page doesn't have a link for the datasheet.

The maximum offset should ideally be lower than 500 uV. The circuit is a current limiter that references to 50 mV.

Thank you,

Heinrich

0 Paul Goedeke over 5 years ago in reply to Heinrich Venter

TI__Mastermind 30600 points

Hi Heinrich,

Thanks so much. I've forwarded your question to some colleagues who have more expertise in precision devices, they'll reply here with a recommendation that meets your 500uV requirement.

The TLV9001 datasheet can be found here: www.ti.com/.../tlv9001.pdf

Thanks,
Paul

0 Paul Grohe over 5 years ago

TI__Mastermind 49966 points

Hello Heinrich,

FYI: The following devices have the same pinout as the LMC7101 (V+ on 2):

LMC7111 (micropower version of LMC7101)
TLV2711 (50kHz, 3mV)
TLV2721 (510kHz,3mV)
TLV2731 (2MHz, 3mV)
TLV6001R (1MHz, 4.5mV)

0 Thomas Kuehl over 5 years ago in reply to Paul Grohe

TI__Guru* 93105 points

Hello Heinrich,

We have not found any TI precision op amp that uses that particular SOT-23 pin arrangement.

Regards, Thomas
Precision Amplifiers Applications Engineering

0 Heinrich Venter over 5 years ago in reply to Thomas Kuehl

Prodigy 70 points

Thank you very much, Paul and Thomas! I'll have to revise the PCB to use the more common pin-out.

Amplifiers

Amplifiers forum

LMC7101: Pin-to-pin compatible part with lower offset?