Hello team,
Is recommended footprint written in datasheet p.14 correct?
C = A - 2B = 1.94mm.
package size is 2mm x 2mm, so soldering may fail.
Could you share with me if you have DXF file for THS9000 recommended footprint?
Best regards,
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hello team,
Is recommended footprint written in datasheet p.14 correct?
C = A - 2B = 1.94mm.
package size is 2mm x 2mm, so soldering may fail.
Could you share with me if you have DXF file for THS9000 recommended footprint?
Best regards,
Hello Sato,
I don't have a .DXF file for the footprint of the device, however I've attached a DXF file of THS9000EVM.
Note that this board was initially done in PCAD & i've imported this into Altium & then exported into .DXF file.. so there may be some error along the conversions.
If you would prefer the original PCAD files or imported Altium files let me know.
Best,
Hasan Babiker
Hello Hasan-san,
Thank you for the file. Can I think datasheet p.14 footprint is not right and we should consider based on package drawing in p.20?
Best regards,
Hello Sato,
Yes, please refer to the package drawing on page 20.
Best,
Hasan Babiker