AMC1211-Q1: Vin goes to GND unexpectedly

NOBUO FUJIHARA

Expert 8575 points

Part Number: AMC1211-Q1

Hi team,

My customer sees Vin signal goes to GND under attached configuration.

Could you suggest potential cause for the phenomenon?

Best regards,AMC1211-Q1_Vin.xlsx

over 3 years ago

0 kai klaas69 over 3 years ago

Guru 140200 points

Hi Nobuo,

why is V1 referenced to GND1? By this you no longer have the protective isolation provided by the AMC1211!! This is dangerous!! V1 should be referenced to GND2, without any connection to GND1.

Kai

0 Tom Hendrick over 3 years ago in reply to kai klaas69

TI__Guru**** 172986 points

Hi Kai,

Hopefully this is just a simulation schematic error.

Fujihara-san,

Please provide the actual schematic.

0 NOBUO FUJIHARA over 3 years ago in reply to Tom Hendrick

TI__Expert 8575 points

Hi Tom-san,

Sorry for confusing.

It's just naming error, GND2 and GN1 is isolated and VIN is referenced to GND2, I will share actual schematic as I get from customer in separate mail.

When ignoring literal error, is there anything suspicious which may cause VIN to *** to static level?

Best regards,

0 NOBUO FUJIHARA over 3 years ago in reply to NOBUO FUJIHARA

TI__Expert 8575 points

Sorry, correct typo.

When ignoring literal error, is there anything suspicious which may cause VIN to *** to static level?

regards,

Amplifiers

Amplifiers forum

AMC1211-Q1: Vin goes to GND unexpectedly