The TI E2E™ design support forums will undergo maintenance from Sept. 28 to Oct. 2. If you need design support during this time, contact your TI representative or open a new support request with our customer support center.

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

VCA821: Differential input voltage level

Part Number: VCA821

Hello team,

The D/S Table 2 specifies that RG = 18Ohm when G=40 (use case is AVMAX=32dB).

Figure 1 specifies that differential input voltage level should be close to 0.1Vpp when RG=18Ohm.

Is the input voltage level limited to 0.1Vpp even when gain control voltage (VG) is changed to smaller value?

How can I check the acceptable input voltage in different VG?

In my use case, VS=+/-5V and RL=100Ohm.

Regards,

Itoh 

  • Hello Itoh,

       From Section 9.3 in the datasheet, it states that the maximum gain for this device is set by Rg and Rf. But with the gain adjust pin or VG, the gain decreases linearly by dB as the voltage on the pin decreases from 2 to 0V (Figure 65 with RG of 18 Ohms). From Figure 1, there is an equation listed: Vin_Max (Vpp) = 2* RG * IRG_Max; this will not include VG and will not be affected at different VGs. The 2 comes from the factor of two before reaching the multiplier from section 10.2.1.2. 

    Thank you,

    Sima