Other Parts Discussed in Thread: TINA-TI, LM8261, OPA2991
I am designing an inverting buffer circuit and a non-inverting buffer circuit.
The output voltage waveform was distorted.
How can I eliminate the distortion of the waveform?
It seems that there is enough bandwidth in the data sheet, but isn't it the correct circuit?
(Figure 14. Gain/Phase vs. Frequency, SNOS975G –MAY 2001–REVISED AUGUST 2015)
- Waveform : Sine wave
- Amplitude : 8Vpp
- Offset : 0V
- Frequency : 800kHz
Supply Voltage : +5V / -5V