This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Tool/software: TINA-TI or Spice Models
You may find my design. I used 4 parallel op-amp for higher current supply. There is no problem with TINA simulations.
my plan is changing current range with relays. Resistor values may change to compensate current range. I'm also planning to measure applied current to compensate leakages.
Paralleling 4 op-amps will reduce noise or not?
Is this possible to get %1 accuracy?
Any suggestion to improve my design?
How will opa209 output leakage current affect my precision?
Also, I want to use triax connector for current output(R_LOAD). How can I drive inner shield of triax(Guard)?
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
This uses an OPA1622 as the main amplifier in the current pump. The OPA1622 should be capable of driving 100mA without assistance, and with relatively low voltage noise (2.8nV/√Hz). I dropped the 10kΩ feedback resistors to 1kΩ both to reduce resistor noise and to reduce the impact of U1's input current noise. I swapped an OPA140 (I'd use a dual, the OPA2140, for U2 and U3) for the OPA627, though the OPA627 could certainly be used in this application. U2 serves double-duty in this application, both as the feedback buffer for the current pump, and as the guard driver for the Triax cable. U3 was added as a buffer ahead of the ADC, as low current ranges (especially with high impedance loads) would likely have too low of an output impedance to adequately drive an ADC.
In order to get a good transient response and reasonable stability, I had to add C1-C4 in parallel with the higher range resistors. These values appear to give decent step responses into resistive loads, but I'd double check stability into reactive loads.
You can download the TINA-TI file I used for the transient analysis here
One further note: I connected the voltage source for the input to R8, rather than R6. This shouldn't affect the overall stability of the circuit, only polarity of the output current. If your application needs a negative output current for positive input voltages, simply connect the voltage source to R6 and ground R8.
Precision Amplifier Applications - TI Tucson
In reply to Alexander Davis:
In reply to Koray Alic:
Any type of serial interface is OK.
My goal is %1 resolution in all current range. This current source will perform as a DC. There is no need for high-speed DACs.
I think that using 16-Bit(or higher) DACs within +-5V range might be enough. (DAC8718)
BTW, there are no many options for higher resolutions within +-5V range.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.