This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: LM258A
The attached file is my design for PT1000 sensor. Sometimes , the LM258 will burn out. I think the cause is the PT1000's fault. I want to protect the LM258. The D56 and R269 are used for the input protection of U11B. The D57 and R20 are used for the input protection of U11A. The R270 is used for the output protection of U11B. Can you give some advice? When the output of the LM258 suffer a high voltage(may be Vcc), how much is the limit current?
Thank you very much.
Regards,Ronald MichallickLinear Applications
TI assumes no liability for applications assistance or customer product design. Customer is fully responsible for all design decisions and engineering with regard to its products, including decisions relating to application of TI products. By providing technical information, TI does not intend to offer or provide engineering services or advice concerning Customer's design. If Customer desires engineering services, the Customer should rely on its retained employees and consultants and/or procure engineering services from a licensed professional engineer (LPE).
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Ron Michallick:
I have two failed examples. In the picture 1 ,the pin 3 &4 and the casing of the LM258 are burning and the pin 7 is some burning. In the picture 2, the casing of two LM258 are burning, but pins are ok.
The Pt1000 sensor is a resistance thermometer. I connect it to the pt1000_01 and pt1000_02 in my circuit. The pt1000 can refer to en.wikipedia.org/.../Resistance_thermometer.
Thank you for your help.
In reply to ccKevin:
Thank you for your response.
1. The circuit that I posted is a new design, not yet implemented.
2. There are five PT1000 channels in my PCB. In the picture 2, two LM258s are damaged but another three LM258s are OK. So, I think that +VCC2 and -VCC2 are OK. You can see the new picture below.
3. The PT1000s are mounted on the casing of my machine that include two motors and one inverter. The machine are our product and the failure events happened in my factory. I think that there are some noise or some induce current in the wires of PT1000 sometimes. On one occasion, I find the one wire of PT1000 is connected to the shielding ground. Although some faults come from the PT1000, but I would to do something to protect my LM258.
4. Can you give me some advice for my new design? Is the R270 for the output protect suitable?
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.