• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 30 subscribers
  • Views 224 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TAS2110: Idle Channel Detection Function

Fernando Santiago
Prodigy 100 points
Part Number: TAS2110

Hi Everyone, 

Working on a PCB with the PN TAS2110 in parallel of the TAS2110 EVK as an example there are some differences on datasheet mentioning and maybe the I²C monitor on the software PPC.

 Idle Channel Detection Switch

 

Switching this function on  PPC, we can see the writing configuration on register Page = 0x00 Address = 0x3E.

In this case, we could not find any references of this function on datasheet. There are described only addresses 0x3D and 0x3F.

Is there a restrict acess for this function?

  • +1
    TI__Guru* 95225 points

    Hi Fernando,

    You're correct, there are some reserved registers that even if used as part of the device configuration, these are not included in the data sheet. Most of these registers are set using a series of coefficients which makes it easier to set using the GUI instead of manually calculating the required values.

    Using the I2C monitor is a good option to make simple I2C changes if needed, however if you want to get all the configuration in a single script, you can always use End System Integration panel.

    Best regards,
    -Ivan Salazar
    Applications Engineer