• State Resolved
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 30 subscribers
  • Views 835 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

PGA2311: Do you have S/N spec of PGA2310, PGA2311 and PGA2320?

Downey Kim
Expert 2675 points

Part Number: PGA2311
Other Parts Discussed in Thread: PGA2310, , PGA2320

Hi TI experts,

We are looking for volume control IC. 

Do you have S/N spec of PGA2310, PGA2311 and PGA2320?

(Test condition : Vol=0dB,Rg=0Ω, A-weight)

Please check it.

Thank you.

  • 0
    TI__Genius 11985 points

    Hello,

    The output noise specification can be found in the AC characteristics section of the datasheet. This value can be used to determine SNR based on the expected amplitude of your output signal.

    For example, from the PGA2311 datasheet (see below) the typical output noise from 10Hz to 20kHz is 2.5 µVrms.

    For a 1 Vrms output signal, the typical SNR is 112dB.

    This will vary slightly when A-weighted as some of the output noise bandwidth is attenuated.

    Regards,

    Zach

  • 0 in reply to Zach Olson
    Expert 2675 points

    Hi Zach,

    Thank you for your help.

    Could you test the SNR by applying an A-weight filter?

    We are comparing volume ICs from TI, Rohm and JRC. JRC and Rohm datasheets have SNR data with A-weight filter applied.

    SNR spec is important to decide Volume IC.

    Please help it.

    Thank you.

  • +1 in reply to Downey Kim
    TI__Genius 11985 points

    HI,

    This is an older part and we do not currently have a set up to test the SNR. We could design a board to test this but development would take a few months. It is likely that the SNR spec you are looking at is derived from the output noise spec as in the example I showed in my previous reply. This is because SNR is simply defined by the ratio of the signal amplitude and the output noise amplitude, typically in dB: SNR(dB) = 20*Log10(Vsignal / Vnoise)

    For your evaluation, you may use the output noise spec given in the datasheet to compare SNR with other devices.