PCM1864EVM: Recommended Setup Procedure When Using PCM1864 in Master Mode

Hi Kato-san

I recall  we had similar situation you faced but when we did the procedure we talk about we could resolve it.

Hi Sanjay-san,

Today, I just tried out to replicate whether PCM1864 works normally with your procedure. As a result, I got a similar experience as you have.
The requirements are as follows.
- PLL output frequency should not exceed 98.3MHz.
- The initial clock divider shown in "Master Mode Only" box should not exceed the 24.58Mhz crystal frequency.

Finally, I would like to confirm just in case, why must Auto-clock detect button be toggled on/off once to achieve the desired frequencies when changing from 96kHz to 192kHz? This seems like an unnecessary step. Could GUI be the cause?

Best regards,
Kato

I believe we saw a situation where there was no data on changing timings.

The procedure outlined helped to get output as 96Khz and 192Khz

Yes we did see case of no Data

Hi Sanjay-san,

There are many unclear points, but I will close this issue.
Thank you for your cooperation.

Best regards,
Kato