• State Resolved
  • Locked Locked
  • Replies 7 replies
  • Subscribers 29 subscribers
  • Views 280 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TAS5751M: Can ADDR be tied directly to ground?

Evan Shultz
Prodigy 30 points
Part Number: TAS5751M

Section 7.6.1.2 indicates that a resistor should be used to pull pin 19 high or low. See page 24 of https://www.ti.com/lit/ds/symlink/tas5751m.pdf?ts=1681193555723.

The EVM shows this on pages 21-23 of https://www.ti.com/lit/ug/slou440/slou440.pdf?ts=1681193762462&ref_url=https%253A%252F%252Fwww.ti.com%252Ftool%252FTAS5751MEVM.

Is it acceptable to tie this pin directly to ground for I2C address of 0x54 if the /FAULT output is not needed?

Thank you!