Hi,
PartNumber: TAS5825M.
input voltage: 24V
Mode: BD mode.
When the rate is set to 768K, it is easy to enter the protected mode. The temperature 60 degrees.
Is there any way to get it out of protected mode?
Thanks!
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi,
PartNumber: TAS5825M.
input voltage: 24V
Mode: BD mode.
When the rate is set to 768K, it is easy to enter the protected mode. The temperature 60 degrees.
Is there any way to get it out of protected mode?
Thanks!
Hello Reed,
What output power are you driving into the device when you see protection get triggered? What is the frequency of the audio signal that is being used?
best regards,
Luis
Hi,when we see protection get triggered,the output power about 5W,the frequency of the audio signal is 768K,HYBRID mode;The same is true with other frequencies
Hi Michael
Have you checked register 0x70 to 0x73, to find out what fault been reported? I'm guessing it's OT fault, because under 24V PVDD, the 4.7uH inductor seems too small, the ripple current too large causing the additional power loss. We could try using 10uH or 15uH.