PCM2912A: PCM2912A

Sam Maedjaja

Part Number: PCM2912A

The PLAY (pin 32) output indicator stays on longer after audio playback is over. Is there any way to configure the PCM2912A to only activate the PLAY pin indicator while playback is active?

over 1 year ago

0 Jeff McPherson over 1 year ago

TI__Mastermind 32925 points

Hi Sam,

The indicator stays on a little longer than when the playback ends to account for extra silence. This is to keep the playback from toggling rapidly during dynamic audio. Unfortunately there's no way to adjust this timing.

Best regards,
Jeff McPherson

+1 Sam Maedjaja over 1 year ago in reply to Jeff McPherson

Prodigy 60 points

Thank you for the information. I wish that it has a tighter hysteresis response.

Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

Audio

Audio forum

PCM2912A: PCM2912A