TLV320AIC14K: TLV320AIC14K

ok thanks

am sending command to the chip through i2c but its not responding, what is the coreect i2c address and smartdm address for a single chip used as a standalone slave

if the control registers cannot be written to through DIN but i2c how then can i write to the register 2 to set the i2c address, which initial address should i use as i2c address when when writing to register 2 to change the i2c device address, 

Hi Christian,

See the table below for the register description. The default address for a single device would be 1000000.

Best regards,
Jeff McPherson

thank you so much, i can read data, but the data i write into the register is not the same with what i read out from it 

Hi Christian,

Can you give an example of what you are seeing?

Take care that you are setting the R/W bit correctly and following the read and write instructions outlined in the data sheet.

Best regards,
Jeff McPherson