The TI E2E™ design support forums will undergo maintenance from Sept. 28 to Oct. 2. If you need design support during this time, contact your TI representative or open a new support request with our customer support center.

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TAS2552: Using Purepath Console 3 to tune TAS2552

Part Number: TAS2552
Other Parts Discussed in Thread: TAS2555, TAS2560

Is it possible to tune TAS2552 with PPC3 as shown in this users guide? If not do we have any software to tune the TAS2552?

  • Hi Jon,

    Unfortunately only SmartAmps after TAS2555 are supported on PPC3.
    TAS2552 is controlled by using the GUI that can be downloaded from its product folder: www.ti.com/.../slac655

    In addition TAS2552 only features IV sense but it does not have embedded processing for speaker protection algorithms; you can compare TAS2552 to TAS2560. Are you intended to perform the algorithms at the host processor?

    Best regards,
    -Ivan Salazar
    Applications Engineer - Low Power Audio & Actuators