TPA0211: Outpur impedance at shutdown

Shinichi Inoue

Guru 20131 points

Part Number: TPA0211

Dear Specialists,

My customer is considering TPA0211 and has a question.

I would be grateful if you could advise.

---

According to the datasheet P.17 9.4.1 Shutdown Mode, while in shutdown mode, the device output stage is turned off.

Does this mean the output is high impedance?

---

I appreciate your great help in advance.

Best regards,

Shinichi

over 5 years ago

0 Ivan Salazar over 5 years ago

TI__Guru** 100065 points

Hi Shinichi,

Considering that when SE mode is enabled Vo- goes into Hi-Z, I think it is OK to assume that when device enters shutdown mode both outputs will go Hi-Z.

Best regards,
-Ivan Salazar
Applications Engineer - Low Power Audio & Actuators

0 Shinichi Inoue over 5 years ago in reply to Ivan Salazar

Guru 20131 points

Hi Ivan,

Thank you for your reply.

I understand output is going to high when the device is shutdown.

I'll share this information with the customer.

I appreciate your great help.

Best regards,

Shinichi

0 Ivan Salazar over 5 years ago in reply to Shinichi Inoue

TI__Guru** 100065 points

Shinichi,

I'll close this thread for now (although not locked).
If you or customer have further questions feel free to reply or start another thread.

Best regards,
-Ivan Salazar
Applications Engineer - Low Power Audio & Actuators

0 Shinichi Inoue over 5 years ago in reply to Ivan Salazar

Guru 20131 points

Hi Ivan,

Thank you for your reply.

I agree.

If the customer has an additional question, I start a nwe threrad.

Best regards,
Shinichi

Audio

Audio forum

TPA0211: Outpur impedance at shutdown