PCM1753: Power-on reset timing

Sadanori Kato

Part Number: PCM1753

Hi,

The power-on reset timing is mentioned in PCM1753 data sheet as follows.
For example, please let me know if you have any advice regarding pop noise such that it is better to apply SCLK to PCM1753 after the power supply has stabilized.

Best regards,
Kato

over 4 years ago

0 Kevin Duke over 4 years ago

TI__Mastermind 46290 points

Kato-san,

I apologize for the delay but we will get back to this and your other two threads by tomorrow US time.

0 Sadanori Kato over 4 years ago in reply to Kevin Duke

Guru 36510 points

Hi Kevin-san,

Thank you for your reply.

For PCM1753 questions, I am looking forward to getting the detailed information from you tomorrow.

Best regards,
Kato

0 Paul_Frost over 4 years ago in reply to Sadanori Kato

TI__Guru 53193 points

Hi Kato-san,

Basically, there is a risk of a pop noise from the device whenever there is a clock error, as well as when the delta-sigma modulator activates. That can occur at startup and is difficult to avoid without an external mute circuit. In general, I recommend that you apply SCK before power-up.

Thanks,

Paul

0 Sadanori Kato over 4 years ago in reply to Paul_Frost

Guru 36510 points

Hi Paul-san,

Thank you for your response.

I understand.

Best regards,
Kato

Audio

Audio forum

PCM1753: Power-on reset timing