Hello,
I'm using DRV135 to convert 400Hz single end input to differential output.
Attached schematics wherein I'm feeding +/- 6.5VRms input to DRV and trying to convert singled end signal to differential signal for better noise immunity.
But unfortunately the I'm not able observe any output. I have an 5k load at the receiving end. I was trying to check the output waveform across 5K load.
Appreciate if you can suggest whether 400Hz singled end input can be used with DRV135 and convert it into differential o/p and check if there is any issues with the circuit
Best Regards,