This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

  • Resolved

PCM5141: PCM5141

Genius 12080 points

Replies: 3

Views: 629

Part Number: PCM5141

Hi Team,

The customer is using PCM5141. The customer uses 1400 PCM5141 devices. But 11 devices are no sound and one device cannot

be adjusted the volume.

The attache is the customer's schematic.

Q1: Is the customer's schematic correct?

Q2: If the customer's schematic is correct, can you give me some suggestions for the customer's issue?

Best Wishes,
Mickey Zhang
Asia Customer Support Center
Texas Instruments

  • Hi, Mickey,

    Thanks for the  post. In general the schematic seems correct, other than the shared output (R375 and R374 should not be connected at the same time), the only thing to consider is that VCOM pin should be tied to GND in VREF mode. Do you know if customer tried the suspect ICs in a different board to discard soldering issues?.

    The non audio issue could be related to a clock error as this part will lead to a mute state if the clocks are not valid. You can verify if there is a clock error by reading the sample rate status bits (Reg. 91 to 94).

    For the device with volume adjust issue, could you check if other I²C functions can be configured (verify I²C communication).

    Best Regards,

      -Diego Meléndez López
       Audio Applications Engineer

  • In reply to Diego Melendez:

    Hi Diego,

    Thanks for your reply. I will confirm with the customer.

    What do you mean by“Reg. 91 to 94”? Does your mean that it it on page 91 to page 94 of the datasheet?
  • In reply to Mickey Zhang:

    Hi, Mickey,

    I meant Registers 91 to 94. These registers are used to monitor the clocking status of the part.

    Best Regards,

      -Diego Meléndez López
       Audio Applications Engineer

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.