Hi Team,
when i use PPC3 to create the model, it show " The fit error too high".
i try to test several speaker, it was same.
is there any mistake?
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi Team,
when i use PPC3 to create the model, it show " The fit error too high".
i try to test several speaker, it was same.
is there any mistake?
Hi Figueroa
I am Arking's colleague Bruce, nice to mail to you!
We also use scale 10V/m setting, but the result is still wrong ( it show's "measure out of range" )
And PPC3 also have laser calibration fouction, after calibration PPC3 shows we should use 1V/m setting.
Do we can do anyother test or check ?
Thank you so much!
Best Regards,
Bruce
Hi Figueroa
My E-mail address is bruce.lin@wpi-group.com
Arking's E-mail address is arking.chiu@wpi-group.com
Thank you so much!
Best Regards,
Bruce