This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

  • Resolved

TAS5508C: automute control register 0x14

Genius 5965 points

Replies: 4

Views: 211

Part Number: TAS5508C

Hello

My customer is using TAS5508C and in the market.

It may be special case, but  customer has pop issue from the market

in case very low level sound with low volume .

So far, customer had been set 0x14 as 14h [ D4=1].

When customer tested 0x14h as 04h [D4=0], pop with automute improved.

Do you agree?”

In TAS5508C data sheet , ”Set input automute threshold less than bit 1 (zero input signal), lowest automute threshold."

in booth of the D4=1, D=0 case.

Best Regards

  • Hi Shibatani-san,
    We are looking into this and will get back you later.
    Best regards,
    Shawn Zheng
  • In reply to Shawn Zheng:

    Dear Shawan san

    Thank you for your reply.

    Would you please advise for my question?  ( this is NOT resolved)

    Best Regards

  • In reply to KANJI SHIBATANI:

    Hi Shibatani-san,

    What is the setting of the 0x15 register (specifically D4-D7)? It may be due to the EQ in the part lowers the output below the input and therefore will trigger an output automute. I am not sure the difference between the 01 and 00 setting for 0x14.

    Justin
  • In reply to Justin Bohr:

    Dear Junstin san

    Thank you for your answer!

    I will talk with customer.

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.