OPA1604: OPA1604

user5889665

Part Number: OPA1604

Dear Ti Expert:

When I flow the document”Analog, Active Crossover Circuit for Two-Way Loudspeakers (TIDU035-December 2013-Revised December 2013) “by John Caldwell. The Figure 4 in page 5, the red curve is the room acoustic effects. So, what is the room size in this simulation by Baffle Diffraction and Boundary Simulator v1.2? Height above Floor? Distance from Rear Wall? Distance from Size Wall?

Best regards!

over 5 years ago

0 Alexander Davis over 5 years ago

TI__Expert 6250 points

Hi user5889665,
I am not sure what settings John Caldwell used for the room response simulation. From what I see in TIDU035, the design does correct for the baffle diffraction of the of the loudspeaker, but I don't see any mention in the design of correcting for room response. If you intend to use the speakers in a particular application (always in a fairly consistent location within a room, for example), I'd use the measurements from that configuration for the room response simulation and design the crossover accordingly.

0 Dennis Goeke over 5 years ago in reply to Alexander Davis

TI__Genius 11135 points

YiFan

We haven't heard back from you so we assume this answered your question. If you need more help just post another rely.

Thanks
Dennis

0 user5889665 over 5 years ago in reply to Alexander Davis

Prodigy 20 points

Thanks Davis!

Bestregards!

Audio

Audio forum

OPA1604: OPA1604