I've installed the GUI application on Windows 10. It runs, but is non-functional. Any attempt to communicate with the board gives the error "Correct drivers not detected".
Please advise.
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
I've installed the GUI application on Windows 10. It runs, but is non-functional. Any attempt to communicate with the board gives the error "Correct drivers not detected".
Please advise.
Hi, Andrew,
Could you take a look at the e2e thread below, please?
https://e2e.ti.com/support/audio/f/6/p/859358/3193198#3193198
Please let me know if the problem persists.
Best regards,
Luis Fernando Rodríguez S.
Hi,
I had tried that previously, without success.
However I tried again, and found that, with modification, it does help. The trick was to remove the jumper (step 7) before trying to update the driver (step 5).
Now it works.
Thanks.