The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LMK1C1104: Please help to check whether the circuit design of LMK1C1104 is correct

Part Number: LMK1C1104

Hi,

Our circuit used LMK1C1104 devices. Our processor requires three 50MHz CMOS clocks at 1.8V. The design is as follows. Please help to check whether there is any problem with this design. Thank you very much.

  • Hello,

    Here is my schematic review:

    LMK1C1104:

    1. CLKIN:
      1. Correct 33 ohm input termination for a LVCMOS input. No changes needed.
    2. 1G:
      1. Tied to VDD to enable outputs. No changes needed.
    3. VDD:
      1. Good power supply filtering circuit. No changes needed.
    4. Outputs:
      1. For LVCMOS outputs, we recommend placing a 33 ohm series resistor on the output pin.
    5. GND:
      1. Tied to GND. No changes needed.

    Regards,

    Kia Rahbar