Other Parts Discussed in Thread: LMK05318BEVM, USB2ANY, CODELOADER
I have created a custom LMK04808B board and broke out the uWire pins to program externally. I have it configured to use:
15k series resistor and 27k pull down resistor for the uWire_LE, uWire_CLK, uWire_Data pins.
For programming I'd like to use the USB2ANY that exists on my LMK05318BEVM board. The schematic for that EVM says the uWire pins are as follows:
Pin #2 - GPIO6 - CS
Pin #3 - GPIO5 - SOMI
Pin #4 - GPIO4 - SIMO
Pin #8 - GPIO2 - SCLK
My question is, which pins on the LMK05318BEVM correspond to the uWire pins on the LMK04808B? The naming schemes don't exactly match up.
I'd like to use either the CodeLoader or TICS Pro
Looking forward to hearing back!
Thank you,