CDCI6214EVM: CDCI6214EVM set require output frequency

? ?

Part Number: CDCI6214EVM

Hi，

Input is 25Mhz, require output frequency1 is 100Mhz,require output frequency2 is 100Mhz,require output frequency3 is 100Mhz,require output frequency3 is 19.2Mhz.

TICS Pro GUI set as below,is it right? Need The Block Diagram to be set?

How to control the CDCI6214EVM to output require frequency?Many thanks.

over 1 year ago

0 vicente flores prado over 1 year ago

TI__Genius 9331 points

Hi,

In the block diagram you can set the desired outputs.

Regards,

Vicente

0 ? ? over 1 year ago in reply to vicente flores prado

Prodigy 20 points

Hi Vicente,

1.First use default configuration(fallback default),Y1 output 156.25M,it is OK.

Then set Wizard Y1 output 100M as below, then click button calculate, but Y1 output still 156.25M,not 100M.

Why does setting Wizard not work? How to make YI output 100M?

2.Set Wizard Y1 output 100M as below,then click button calculate,but Block Diagram Y1 is not 100M.

Does Wizard and Block Diagram relate to each other?

0 vicente flores prado over 1 year ago in reply to ? ?

TI__Genius 9331 points

Hi,
Use the block diagram to set the frequencies instead of the configuration wizard. In the block diagram all the way to the right, you can directly see if the output frequency has been changed/set and to which registers respectively.

Regards,

Vicente