LMX2582EVM: Need a user guide for TICS Pro Software. Unable to change frequency.

Pawan Kumar Venkatesh

Part Number: LMX2582EVM

Hi,

I'm unable to change the frequency on LMX2582EVM. It always seems to be stuck on 3.62 GHz, irrespective of what you specify on the software. Here are the steps I followed.

1. Reset the registers

2. FcalEn = On

3. Set the frequency on the PLL section of the software

4. Load registers

So, I was wondering if there is any user guide for the TICS Pro software. If not, could someone help me with the steps to change the frequency?

I have two of these modules, and both have the same issue, so it can't be the hardware.

Thank you!

over 1 year ago

0 Noel Fung over 1 year ago

TI__Guru* 88030 points

Hi Pawan,

After changing the vco frequency, you need to program R0 once again to trigger VCO calibration. In the GUI, you could toggle the FCAL_EN bit (i.e. uncheck and then check the box) or you could simply click the Load Registers button to program all registers.

0 Pawan Kumar Venkatesh over 1 year ago in reply to Noel Fung

Prodigy 10 points

Unfortunately, this did not solve the issue. The spectrum analyzer only shows a peak at 3.62GHz.

0 Noel Fung over 1 year ago in reply to Pawan Kumar Venkatesh

TI__Guru* 88030 points

Hi Pawan,

If you use TICS Pro Default Mode configuration, did you get 1.8GHz signal?

0 Pawan Kumar Venkatesh over 1 year ago in reply to Noel Fung

Prodigy 10 points

Hi Noel,

Thanks for getting back to me.
I'm not sure what the default mode configuration is, but I assume it is when you reset all the registers. Here is the procedure I followed:
1. Toggled the Reset button on the GUI.
2. Checked the FCAL_EN on the GUI.

After this, I got the attached results on the spectrum analyzer. The peaks are at 1.72GHz, 3.45GHz, and 5.17GHz.

Is this what is expected?

+1 Noel Fung over 1 year ago in reply to Pawan Kumar Venkatesh

TI__Guru* 88030 points

HI Pawan,

Please follow EVM user's guide for EVM setup.

Open TICS Pro, select the right device and then select Default Mode.

You should get below configuration.

In the menu bar, click USB communications, then Write All Registers. You should get it lock to 1.8GHz output. The on-board LED should also light up to indicate lock.

0 Pawan Kumar Venkatesh over 1 year ago in reply to Noel Fung

Prodigy 10 points

Hi Noel,

Thank you so much for your help on this. Your suggestion resolved my issue.

Clock & timing

Clock & timing forum

LMX2582EVM: Need a user guide for TICS Pro Software. Unable to change frequency.