Hi, Support Team
We will use CDCE913 and TS5A63518 as below chart
Please help to review and advise.
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Ensure that you have pullup resistors for the I2C connections. Make sure that the traces to the other devices are impedance matched - a 22-Ohm resistor is series with the output trace is recommended. For best performance, it is recommended to isolate the VDD and VDDOUT supplies using a ferrite bead.
we will selection of a ferrite bead on the following three parameter:
DC impendance(0 to 5ohm)
DC current( 15% margin + max supply current)
resonance near low freuency(10-100kHz)
if any, Please advise me.