The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.

  • State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 21 subscribers
  • Views 233 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LMK03328: Disable output

Austin Do
Expert 3075 points
Part Number: LMK03328

Hello team,

Is there specific method to disable all outputs(only output buffer block) thru I2C command?

Best Regards,

Austin

  • +1
    TI__Mastermind 20950 points

    Austin,

    The SYNCN event can be used to disable all outputs, if the outputs being synchronized afterwards is fine.

    The SYNCN_SW bit (R12[6]) controls this function.

    Otherwise, the outputs can be individually powered down, or a soft chip reset can be performed (which would also result in VCO calibration).

    Thanks,

    Kadeem