CDCVF2510A: About app note and the bypass mode

Noriyuki Takahashi

Part Number: CDCVF2510A

Tool/software:

Hi team,

Customer is looking for appplication note, SCAA039 that is described in the datasheet, but I couldn't find it. Could you share it?

Then, the PLL of the device can be bypassed by connecting AVDD to GND. Is it OK to use this mode in normal operation?

Customer considers to use the device with this mode.

Regards,

Noriyuki Takahashi

3 months ago

0 Andrea Vallenilla 3 months ago

TI__Genius 10975 points

Noriyuki,

I'll get back to you by tomorrow. I'm also not sure where that app note is and I'm reaching out to my internal team to figure it out.

Best,

Andrea

0 Noriyuki Takahashi 3 months ago in reply to Andrea Vallenilla

TI__Genius 10140 points

Andrea

This is kind reminder. Are there any feedback?

Regards,

Noriyuki Takahashi

+1 Andrea Vallenilla 3 months ago in reply to Noriyuki Takahashi

TI__Genius 10975 points

Noriyuki,

Yes, please strap AVcc/AVdd to GND to operate this device as a buffer and bypass the PLL. By doing this, this will act as the normal operation of the device (i.e normal operation will be to bypass PLL and have device behave as buffer).

Best,

Andrea

Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

Clock & timing

Clock & timing forum

CDCVF2510A: About app note and the bypass mode