• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 22 subscribers
  • Views 137 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LMK04832-SP: Reg- Frequency Planning for LMK04832-SP

venkat raj
Prodigy 190 points
Part Number: LMK04832-SP
Other Parts Discussed in Thread: LMK04832-SEP

Tool/software:

Dear sir,

In my application, I am using LMK04832-SP part. In LMK04832-SP datasheet there is no data regarding  Frequency Planning.

But while checking the LMK04832-SEP datasheet the below data for Frequency Planning was given.

Is this recommended to be followed in the LMK04832-SP part as well?

Then In LMK04832-SP ,If I connect CLKOUT4 , CLKOUT6 and CLKOUT7 with different frequency what issue can be expected in output.

Regards,

Venkatraj V

  • 0
    TI__Mastermind 29542 points

    Hello Venkatraj, 
    Yes, you can follow the frequency planning suggestion. 
    Also, should keep in mind the physical pin locations and keep identical clocks near each other to prevent xtalk. 
    Isolation between output supplies should be considered if operating with various output frequencies. 

    p.s. same applies to 4832 ^

    Best regards, 

    Vicente