I am using this IC to distribute signal (2-5KHz) tousing this IC and drive to 2 m length.Whether this IC is sufficient for drive or i need to use LVDS driver additionally.
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
I am using this IC to distribute signal (2-5KHz) tousing this IC and drive to 2 m length.Whether this IC is sufficient for drive or i need to use LVDS driver additionally.
At Receiver end design is already frozen and LVDS Receivers have been used.I need to distribute timing signal into 90 lines.I was using this IC for distribution.I need to drive for 1.5 m length.Any additional circuit is required??
Dear Lane,
Thank you for your reply.I will try to simulate the same.As per data sheet this IC is designed for 50ohm transmission line but I have to use PTFE wires to carry this timing signal(2KHz)to another module(FPGA based).Will it be alright??plz confirm.
Regards,
Amrita Gupta