CDCM6208V1EVM: Using the EVM for bring-up

Elder Costa17

Part Number: CDCM6208V1EVM
Other Parts Discussed in Thread: CDCM6208

I need to do a board bring-up and I am wondering if I can use the EVM as an USB-I2C bridge to control the on-board CDCM6208.

0 Lane Boyd over 5 years ago

You can use header JMP9 to access I2C (or SPI) signals. Be sure to set SW2 to the ON position to enable I2C.

Kind regards,
Lane

0 Elder Costa17 over 5 years ago in reply to Lane Boyd

Expert 2825 points

Hello, Lane.

Thank you very much.

Elder.

Clock & timing forum