Other Parts Discussed in Thread: LMX2581
Hello Experts,
I run PLLatinum to simulate LMX2581. I tried to set EVM condition as below, but PLLatinnum returned different Loop Filter value than EVM. How did you determine loop filter for EVM? I want to get loop filter value as same as EVM by PLLatinum.
- Vin=100MHz
- Vout=2700MHz
- Fpd=20MHz
- Loop Bandwidth=27.8KHz
- Charge Pump Gain=2400uA
- VCO Frequemcy=2700MHz
* I referred User's Guide(SNAU136C), p4, "1.3 Loop Filter Values and Configuration Information" section.
Best Regards,
Fujiwara